ARGOX X-3200 PPLB DRIVER DOWNLOAD

Close the peeler module using the peel-off mechanism release lever. Assign the directory to keep Seagull driver, for example: The adjusting steps are as follows: Please contact your local Argox reseller if you need this cable. Check if the communication cable parallel or serial is connected securely to your parallel or serial port on the PC and to the connector on the printer at the other end. Close the top access door and turn on the printer or press the FEED button if the printer is already on.

Uploader: Sakree
Date Added: 20 March 2007
File Size: 11.45 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 10260
Price: Free* [*Free Regsitration Required]

If the printer supports Plug-and-Play, and you have successfully connected it using a USB cable, then the Windows Add Hardware Wizard will automatically detect the printer and display a dialog that allows you to install a driver. When using a keyboard or barcode reader communicating with a host through the Centronics or serial port is prohibited.

Clean the print head as follows: If labels with notches or holes are in use, follow the steps below to check position of the label sensor: This utility enables to true type font TTF and load the fonts into printers. The default setting when shipped from Argox factory is shown as Figure 2 — the two arrows are in line with the black line.

  CREATIVE LABS SB0220 WINDOWS 7 DRIVER DOWNLOAD

Buttons There are three buttons, each with two basic functions. The printer will then feed the labels through the cutter automatically.

ARGOX X-3200

Print Head Pressure Printing quality can be fine adjusted based on which area on the label the printing quality discrepancy is located. Loose the three screws from Tear-off Bracket and then remove Tear Bracket.

The X provides outstanding value as it delivers industrial strength high quality printing for a wide range of labels. W mm x H mm x D mm. Make a form for the keyboard.

Figure 1 Figure 2 93 Guillotine Cutter with Paper Jam If there is paper jam inside guillotine cutter, check in Figure 1 and find where the screw under guillotine cutter. Troubleshooting Normally, if the printer is in not working properly, the “READY” LED blinks argod, and printing and communication between the host and printer stops. After media calibration is finished, printer stores settings into its flash.

Choose Industrial Barcode Printers on the screen, go to X product page, click x-32000 version of Seagull driver and then start installation: Repeat the same process until the printing quality is well balanced on both ends of the label.

Unwrap the ribbon and separate the ribbon roll x–3200 the bare core. The X industrial barcode printer features dpi printing for high quality text and graphics on fabric labels, safety labels and labels for small items such as jewelry. Ribbon sensor error Replace ribbon sensor Note: For the XVL, ignore this step.

  EVEREST HY8131A WEB CAMERA DRIVER DOWNLOAD

Argox x pplb drivers download

On the contrary, DHCP setting is enabled. Printer will enter Dump mode after ;plb configuration. Close the print head latch.

Remove the top covers on both left and right sides. Press the FEED button for the next language. Related questions Dear Sir, Can i connect directly to Argox ppla printer using php?

For the XVL model, ignore this step. Available only in PPLZ printer language.

Assemble the related components for both left and right sides. Memory full Check graphics and soft fonts from host. Release the button when the cutter starts cutting. Windows Vista, Windows 7, Windows 8. After the cutter is installed, install media and ribbon. It’s a community-based project pplg helps to repair anything.